Dodge 2004 Neon SX2 Diagnostic Manual page 398

DRIVEABILITY - NGC
P0111-INTAKE AIR
Continued
TEST
3 Turn the ignition off.
Disconnect the IAT Sensor harness connector.
Ignition on, engine not running.
With the DRBIII , read the IAT Sensor voltage.
Is the voltage above 4.9 volts?
Yes → Go To 4
→ Go To 7
No
4 Turn the ignition off.
Disconnect the IAT Sensor harness connector.
Using a jumper wire, jumper across the IAT Sensor harness connector.
Ignition on, engine not running.
With the DRBIII , read the IAT Sensor voltage.
Is the voltage below 0.1 volt?
Yes → Replace the IAT Sensor.
→ Go To 5
No
5 Turn the ignition off.
Disconnect the IAT Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K21) IAT Signal circuit from the IAT Sensor harness
connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Go To 6
→ Repair the open in the (K21) IAT Signal circuit.
No
6 Turn the ignition off.
Disconnect the IAT Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K167) Sensor ground circuit from the IAT Sensor
harness connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → NOTE: Before continuing, check the PCM harness connector
→ Repair the open in the (K167) Sensor ground circuit.
No
TEMPERATURE
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
terminals for corrosion, damage, or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
SENSOR
62
PERFORMANCE
APPLICABILITY
All
All
All
All
—