Dodge 2004 Neon SX2 Diagnostic Manual page 69

AIRBAG
PASSENGER SQUIB 1 CIRCUIT SHORT —
TEST
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Passenger Airbag connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active airbag DTCs.
Does the DRBIII show PASSENGER SQUIB 1 CIRCUIT SHORT?
Yes → Go To 3
→ Replace Passenger Airbag in accordance with the Service Infor-
No
3 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Airbag Control Module connector
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adapter to the Airbag Control Module connector.
Disconnect the Load Tool from the Passenger airbag connector.
Measure the resistance between Passenger Squib 1 Line 1 and Squib 1 Line 2 circuit
at the Passenger Airbag connector.
Is the resistance below 10K ohms?
Yes → Repair Passenger Squib 1 Line 1 circuit short to Passenger Squib
→ Replace the Airbag Control Module in accordance with Service
No
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
ACTION
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
1 Line 2 circuit.
Perform AIRBAG VERIFICATION TEST - VER 1.
Instructions.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
62
APPLICABILITY
All
All