Dodge 2004 Neon SX2 Diagnostic Manual page 658

STARTING
*ENGINE CRANKS DOES NOT START —
TEST
28 Turn the ignition off.
Remove the Fuel Pump Relay from the PDC.
Disconnect the Fuel Pump Module harness connector.
NOTE: Check connectors - It is critical that the connector is free from any
signs of corrosion or deformities
Measure the resistance of the Fuel Pump Relay Output circuit from the relay
connector to the fuel pump module connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Fuel Pump Relay.
→ Repair the open fuel pump relay output circuit.
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Continued
322
APPLICABILITY
All