POWER DOOR LOCKS/RKE
DRIVER DOOR SWITCH SHORTED OR STUCK —
TEST
3
NOTE: This test is for vehicles with VTSS. If this vehicle is not equipped
with VTSS, answer YES to the question and continue.
Turn the ignition off.
Disconnect the Remote Keyless Entry module connector.
Remove the driver door inner trim panel.
Disconnect the Cylinder Lock Switch connector.
Measure the resistance between ground and the driver Door Switch Mux circuit
(cavity 10).
Is the resistance below 8000.0 ohms?
Yes → Go To 4
→ Replace the Cylinder Lock Switch.
No
4
Turn the ignition off.
Disconnect the Door Lock Switch connector.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance between ground and the driver Door Switch Mux circuit
(cavity 10).
Is the resistance below 8000.0 ohms?
Yes → Repair the Driver Door Switch Mux circuit for a short to ground.
→ Replace the Door Lock Switch.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
182
APPLICABILITY
All
All