Dodge 2004 Neon SX2 Diagnostic Manual page 148

ABS MESSAGE NOT RECEIVED —
TEST
1 With the DRBIII , attempt to communicate with the ABS, ACM, EATX, SBEC, or
SKIM module.
Was the DRBIII able to I/D or communicate with the Module in question?
Yes → Go To 2
No
2 With the DRBIII , erase DTCs.
Cycle the ignition, wait approximately 1 minute.
With the DRBIII , read DTCs.
Did the DTC reset?
Yes → Replace the Instrument Cluster in accordance with the Service
No
ACTION
→ Refer to Communication category for the related symptom(s).
Information.
Perform BODY VERIFICATION TEST - VER 1.
→ The condition is not present at this time. Monitor DRBIII
parameters while wiggling the related wire harness. Refer to any
Technical Service Buletins (TSB) that may apply. Visually inspect
the related wiring harness and connector terminals.
INSTRUMENT CLUSTER
Continued
141
APPLICABILITY
All
All