Dodge 2004 Neon SX2 Diagnostic Manual page 141

EXTERIOR LIGHTING
*HIGH BEAM HEADLAMPS WILL NOT TRN ON —
TEST
5 Turn the ignition off.
Check Circuit Breaker 2
Is Circuit Breaker 2 open?
Yes → Replace the open Fuse.
→ Go To 6
No
6 Disconnect the Multifunction Switch connector.
Turn the headlamps on.
Measure voltage of the Fused B+ Circuit in the Multifunction Switch connector.
Is the voltage below 1.0 volt.
Yes → Go To 7
→ Repair the Dimmer Switch Low Beam Output Circuit for an open
No
7 Disconnect the Multifunction Switch connector.
Turn the headlamps on.
Connect a jumper wire between the Dimmer Switch Low Beam Output Circuit and
the Dimmer Switch High Beam Output Circuit in the Multifunction Switch connec-
tor.
Did the High Beam Headlamps come on?
Yes → Replace the Instrument cluster.
→ Replace the Multifunction Switch.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
condition.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
134
Continued
APPLICABILITY
All
All
All