Delayed Start Of A Wash Program - GIRBAU HS-6013 Operation Instructions Manual

4.8. DELAYED START OF A WASH PROGRAM

Allows the user to program the start time of a wash cycle.
Programming the start time:
Load the washing machine, close the door and select the wash program.
Press the key C on the numerical keyboard. On the screen, the current time will appear. Format of 24 hours.
The keys ---3--- ---4--- of the multi-function keyboard allows selecting minutes / hours. The value being
selected blinks.
Program the desired starting time on the numerical keyboard and confirm with the key START. The start
time remains on the screen.
The keys STOP or ---↵--- on the multi-function keyboard cancel the delayed start.
4.9. UNBALANCE CONTROL
Before starting spin, the electronic control of the washing machine checks the correct distribution of the load.
If it detects that the load is not well distributed and that can cause an excessive unbalance during the spin, a
new positioning of the clothes will be carried out.
If there's still unbalance during the spin of the last phase, the washer can end the washing cycle reducing the
spin speed.
Three unbalance levels, which cause different reactions in the washing machine, have been established.
The unbalance level detected is viewed on the INFO screen when the washing machine executes the spin cycle.
NO unbalance............ : permits any spin cycle.
LOW unbalance ........ : permits medium speed spin cycles and high speed spin cycles after a determined
MEDIUM unbalance .. : permits medium speed spin cycles; after a certain number of attempts, it reduces
HIGH unbalance ........ : does not permit the spin cycle.
For security, a microswitch controls the movement of the suspended group of the washing machine. It is
activated by itself in cases of extreme unbalance. This device impedes executing spin cycles.
To improve the efficency of the spin of the washer it's advisable to:
•
Load the washing machine up to its nominal value, using the total capacity of the drum.
•
Load the washer with homogeneous loads
Executing Programs
number of attempts.
the speed of the high spin cycles.
15
Cod. 429159
Rev. 01/0306