Initial Start-Up - GIRBAU HS-6013 Installation Instructions Manual

COIN CONTROL units:
To enable the external dosing system, you must modify the external dosing parameter at the MODIFICATION
menu (see the Advanced Operation Instructions, for HS-6 / EH COIN CONTROL at the manufacturer's
website: www.girbau.com)
(USA/CANADA www.cont-girbau.com

3.6. Initial Start-up.

THE WASHER MUST BE PUT INTO SERVICE BY AN AUTHORIZED SERVICE TECHNICIAN.
Before the initial STARTING, make sure that you accomplish the following points:
•
Remove all packaging materials (Break them down in order to appropriately recycle them)
•
Remove all tools used during the installation.
•
Verify that all accessories have been removed from the drum interior.
•
Verify the correct installation of all the accessories necessary for the washer operation.
•
Check that the electrical installation corresponds with the voltage and the frequency of the machine.
•
Verify that the four washer feet come in contact with the floor.
•
Verify that all the shipping restraints are removed.
•
Connect all the water, steam (steam heated washers) and power inlets according to the technical
specifications.
•
Open the manual water inlet valves (and steam if necessary) and check for any leaks around the manual
flow valves and connection couplings.
•
Connect the electrical supply.
•
Check the operation (it is recommended to use the TEST program).
•
Keep the manual in a safe place and in good condition for its possible consultation.
•
Before washing clothes for the first time we recommend to run a complete cycle with detergent (1/4 the
normal recommended amount).
3.7. Emergency stop in coin-op installations
IN ACCORDANCE WITH SAFETY REQUIREMENTS FOR INDUSTRIAL MACHINERY Standard (UNE-
EN ISO 10472-1,5-2) AND OTHER SAFETY REQUIREMENTS, THE LAUNDRY OWNER / USER IS
RESPONSIBLE FOR INSTALLING A REMOTE LOCATED EMERGENCY STOP DEVICE, CONNECTED
TO EACH MACHINE.
Device features
To be located in a visible place, separated from all machines and easily accessible.
To break the electrical supply for all machines.
To safely isolate all machines at maximum consumption.
To need reinstating (the whole installation) after the Emergency Stop Push-button has been unlocked.
Installation
)
22
Cod. 429043
Rev. 02/1206