Troubleshooting - GIRBAU HS-6013 Operation Instructions Manual

12. TEXT MESSAGES
This menu allows writing three text messages and determining when they appear after a number of hours
programmed.
12.1 PROGRAMMING MESSAGES AND MOMENT OF DISPLAY
Access to the TEXT MESSAGES menu following the steps indicated in section 10.
The three text messages available appear on the screen.
An asterisk next to some of the messages indicates that the message is programmed.
Select one of the three messages and confirm the selection by the ·SEL· key on the multi-function keyboard.
The following screen appears.
In the position PROGRAMMED TIME, programme time the message has to appear using the numeric
keyboard.
In the position ACCUMULATED TIME will appear the time elapsed since the message was programmed.
6
Press key ·· and access to the text line. Enter the text of the message. Follow the indications for text
writing in section 7.2.
Register in the memory the programming and start the time counting by pressing key
Other actions:
•
The ·RESET· key on the multifunction keyboard re-initialises time counting.
•
Erase the programming of the message duration by programming 00000 in the position TIME
ACCUMULATED.
•
Erase the programmed message by key C on the numeric keyboard.

13. TROUBLESHOOTING

Some of the washing machine's operating problems can be solved through the intervention of the user.
These problems are detailed below.
Should you have any questions, remember to consult the Authorised Technical Service.
13.1 What to do when...
....the wash cycle ends with the report: PERSISTENT UNBALANCE.
•
This report indicates that the final spin cycle is not possible because the load is unbalanced.
•
Unload the machine and load it again.
•
Begin the wash cycle and accelerate the program to the last phase.
•
The washing machine will repeat the last spin cycle without refilling with water.
•
If the problem persists, or occurs often, call the Authorised Technical Service.
....the machine makes a strange noise during the spin cycle.
•
Check the levelling of the machine. See Instruction Manual for Installation.
•
Tighten the locking screws on the outside panels.
•
If the problem persists, call the Authorised Technical Service.
.... the door may have a leak
•
Clean the door seal of any possible deposits or remains of cloth
.... there is water leaks inside the washer cabinet.
•
Check the outlet draining pipe.
•
Check the seals on the water inlet hoses; tighten the connection couplings.
•
Check the condition of the door seal and if there are any ruptures.
•
if the problem persists, seal all of the water inlets and call the Authorised Technical Service.
....you have forgotten the access code for the operating modes
•
Call the Authorised Technical Service.
.... the clock stops working correctly
•
Possible battery failure. Call the Authorised Technical Service to have it replaced.
Text Messages / Troubleshooting
44
↵
.
Cod. 429159
Rev. 01/0306