Modifying Programs - GIRBAU HS-6013 Operation Instructions Manual

8. MODIFYING PROGRAMS

The objective of this menu is providing the user with resources that allow:
modifying programs.
•
programming new programs from the copy and modifying programs in use.
•
• eliminating programs out of use with the objective of maintaining the maximum capacity of the
microprocessor memory.
Some of the options offered by the MODIFICATION menu are grouped into submenus.
General map of the MODIFICATION menu.
8.1 MODIFYING A PROGRAM (from number 21)
Modification options:
Modifying a program name.
Modifying the content of a phase
Inserting a phase
Erasing a phase.
8.1.1. Selecting a program and modifying the name
Starting at the main menu (section 4.1), select the icon corresponding to the PROGRAMMING
mode (section 6.3). The icons of the distinct menus will appear.
Select the MODIFICATION icon.
The icons of the distinct modification options will appear.
Consult general map of the MODIFICATION menu in initial section of chapter 8.
Select the MODIFYING A PROGRAM icon. The list of programs will appear.
Select the program that you want to modify.
Confirm the selection.
The modifying program name screen appears. If you want to introduce or modify the
program name, continue on this screen following section 7.2.
Confirm the modification. The next screen is accessed.
Modifying programs
Modifying a program (section
8.1):
Selecting the program.
Option to modify the program
number.
Selecting the phase.
Four submenus will later appear.
Copying an existing program into a new program (section 8.2)
Blocking an existing program from operating (section 8.3)
Erasing an existing program (section 8.4)
Modifying the content of a phase.
Inserting a phase before the selected
phase.
Inserting a phase after the selected
phase.
Erasing a phase
30
Cod. 429159
Rev. 01/0306