Messages Displayed On The Client Computer - Ricoh Pro C651ex Operating Instructions Manual

3. Troubleshooting When Using the Scanner Function
Message
"You do not have the
privileges to use this function."
"Please wait for the current
job to finish."
"Requested job will start after
3
current job finishes."

Messages Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error messages displayed on the
client computer when using the TWAIN driver.
Message
"Cannot add any more
scanning mode."
"Cannot specify any more
scanning area."
"Communication error has
occurred on the network."
"Error has occurred in the
scanner driver."
66
Causes
The logged in user does not
have permission to use the
selected function.
The scanner function was
used to scan an original
while printing was being
performed by another
function.
Causes
The maximum number of scan
modes is already registered.
The maximum number of scan
areas is already registered.
A network communication
error occurred.
A driver error has occurred.
Solutions
Contact your administrator about
permission for the required function.
Wait a while. Scanning will start
automatically when printing finishes.
Solutions
The maximum number of modes that can
be stored is 100. Delete unnecessary
modes.
The maximum number of scanning areas
that can be stored is 100. Delete
unnecessary scanning areas.
Enable TCP/IP on the client computer.
• Check whether the network cable
is connected correctly to the client
computer.
• Check that the client computer's
operating system has detected the
Ethernet board.
• Enable TCP/IP on the client
computer.