Test Print / Zero Dollar Indicia; Using Presets; Selecting The Normal Preset; Selecting A Custom Preset - Pitney Bowes DM300c Operator's Manual

Test Print / Zero Dollar Indicia

From time to time you or a Pitney Bowes Service Representative
may want to conduct a test print to determine if your DM Series
print mechanism is operating correctly. We recommend that you use
the Test Print or Zero dollar Indicia so that you do not waste your
postage funds. The following procedure outlines how to process a
Test Print:
1. At the "Home Screen" using the numeric keypad type in '0.00'
and press Enter.
2. The screen will now display "$0.00" in the top right hand corner
with three lines on the left and right side. You are now ready to
print the indicia.
3. Place envelope in feed deck to print (see section 3-9) or Press
the Tape button to print indicia on tape (see section 3-13).

Using Presets

Selecting the Normal Preset

The Normal Preset is the factory default setting which contains
no predetermined mail job settings (e.g., Postage Value, Class, or
Weight).
Pressing the Normal Preset key will clear your current mail job
settings and take you back into Seal Only Mode. From here you can
begin a new transaction.

Selecting a Custom Preset

1. At the Ready screen on the IntelliLink
Custom Presets key. The display lists all presets stored.
2. Press the corresponding key of the preset you wish to select.
The display then shows the selected custom preset values.
3. Print the envelope as described in Printing Postage on an
Envelope in this chapter, or: Print tapes as described in Printing
Postage on Tape Strips (or Sheets) in this chapter.
If you'd like to set up custom preset values or change them, see
Chapter 5.
SV61991 Rev. A
3 • Running Mail
Control Centre, press the
TM
3-17