Starting Circuit Cut-Off System Operation (Xp500) - Yamaha XP500 Service Manual

ELECTRIC STARTING SYSTEM
EAS00756
STARTING CIRCUIT CUT-OFF SYSTEM
OPERATION (XP500)
If the engine stop switch is set to "
main switch is set to "ON" (both switches are
closed), the starter motor can only operate if
the following conditions are met:
• A brake lever is pulled to the handlebar (the
1 Battery
2 Main fuse
3 Main switch
4 Ignition fuse
5 Engine stop switch
6 Starting circuit cut-off relay 1
7 Sidestand switch
8 Signaling system fuse
9 Front brake light switch
0 Rear brake light switch
A Start switch
B Starter relay
C Starter motor
8 - 17
brake light switch is closed) and the side-
stand is up (the sidestand switch is closed).
– +
ELEC
" and the