Checking The Chain Drive Oil Level - Yamaha XP500 Service Manual

CHECKING THE CHAIN DRIVE OIL LEVEL

1
CHANGING THE COOLANT/
• Use only distilled water. Soft water may
be used if distilled water is not available.
• If coolant comes into contact with painted
surfaces, immediately wash them with
water.
• Do not mix different types of antifreeze.
11.Install:
• radiator cap
12.Fill:
• coolant reservoir
(with the recommended coolant to the maxi-
mum level mark a)
13.Install:
• coolant reservoir cap
14.Start the engine, warm it up for several min-
utes, and then turn it off.
15.Check:
• coolant level
Refer to "CHECKING THE COOLANT
LEVEL".
NOTE:
Before checking the coolant level, wait a few
minutes until it settles.
16.Install:
• inner fender
• lower side cover mole (left and right)
• coolant reservoir cap access panel
Refer to "SIDE COVER MOULDINGS AND
LEG SHIELD".
• front side cover mole (left and right)
• left footrest board mat
Refer to "FRONT COWLING".
CHECKING THE CHAIN DRIVE OIL LEVEL
1. Stand the scooter on a level surface.
NOTE:
• Place the scooter on a suitable stand.
• Make sure that the scooter up right.
2. Remove:
• chain drive case cover 1
3 - 43
CHK
ADJ