Installing The Chain Drive - Yamaha XP500 Service Manual

CHAIN DRIVE

INSTALLING THE CHAIN DRIVE

1. Install:
• chain drive assembly
• swingarm
• pivot shaft
• washer
• nut
2. Tighten:
• swingarm bolt
3. Tighten:
• pivot shaft
• nut
NOTE:
• With your fingers, screw in the pivot shaft
until it touches the collar and then tighten the
pivot shaft to the tightening torque.
• Tighten the nut to the tightening torque.
• Install the shock absorber and rear wheel
after the swingarm is installed.
4. Fill:
• chain drive oil
Refer to "CHANGING THE CHAIN DRIVE
OIL" in chapter 3.
5. Check:
• chain drive oil level
Refer to "CHECKING THE CHAIN DRIVE
OIL LEVEL" in chapter 3.
5 - 92
ENG
40 Nm (4.0 m · kg, 29 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
100 Nm (10.0 m · kg, 72 ft · lb)