Yamaha XP500 Service Manual page 241

b
a
2
FRONT AND REAR BRAKES
2. Install:
1
NOTE:
• Install the brake master cylinder holder with
• Align the brake master cylinder with the pro-
• First, tighten the upper bolt, then the lower
3. Install:
Proper brake hose routing is essential to
insure safe scooter operation. Refer to
"CABLE ROUTING" in chapter 2.
NOTE:
• While holding the brake hose, tighten the
• Turn the handlebar to the left and to the right
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection a on the brake
master cylinder.
4 - 43
• brake master cylinder 1
• brake master cylinder holder 2
• holder bolts
10 Nm (1.0 m · kg, 7.2 ft · lb)
the "UP" mark facing up a.
jection b on the handlebar.
bolt.
• copper washer 1
• brake hose 2
• union bolt 3
30 Nm (3.0 m · kg, 22 ft · lb)
WARNING
union bolt as shown.
to make sure that the brake hose does not
touch other parts (e.g., wire harness, cables,
leads). Correct if necessary.
CAUTION:
CHAS
New