Table of Contents
Advertisement
Ava 500 IT Administrator's Guide
The EX60 is firewalled behind the NAT on the base. These settings in the H323 section are required to support
that configuration:
•
NAT Mode = On
•
NAT Address = The IP address assigned to the Ava 500 when it connected to the WLAN
If corporate policies require an administrator password to access the EX60, this password needs to be configured
on the base CPU as well. The password should be set not to expire.
If the password is changed without a corresponding change to the base CPU configuration, the
Ava 500 will no longer function.
To access the Cisco EX60's web configuration interface, enter:
http://Ava500IPAddress
where 'Ava500IPAddress' is the address provided to the Ava 500 when it is configured to connect to the WLAN.
Configuring the Ava 500 App
The iRobot Ava 500 Control Application is compatible with any platform that supports iOS version 7 or higher.
Users must be configured in the Ava 500 Cloud Service before they can use the Ava 500 App. The IT
Administrator can manage users through the Ava 500 IT Administrator Console.
An instruction sheet is provided in Appendix A to send if users are going to download and configure the App
themselves.
First Time Installation
To configure the Ava 500 App on the iPad or iPhone for the first time, first download the Ava 500 App from the
App Store, and then include a reference to the Ava 500 Cloud Service server in the iPad settings.
1. In the App Store, tap the search box in the upper right hand corner and search for 'Ava 500'.
2. Tap the iRobot Ava 500 App and install it. An Apple ID is required.
3. Tap the Ava 500 icon to start the application.
4. Enter the Ava 500 Cloud Service Hostname and the Username and Password. The Cloud Service Hostname
is only entered once on the initial login.
5. To skip the login dialog in the future, go to the App Settings and set Automatically Log In to On.
HTTP proxy authentication can be configured in WiFi Settings as either Manual or Automatic. Because iOS does
not pass proxy login information to the Control App, if the Control App detects that proxy authentication is enabled
then proxy fields are added to the Control App login page. If proxy configuration is Manual, only the proxy
password is required. If the proxy configuration is Automatic, both the proxy username and password are
required. Once login is complete, if the App is configured to automatically log in, the proxy login information is
Version 1.2 – 012415
Page 25
iRobot Proprietary
System Configuration
Advertisement
Table of Contents
