Enable Warping And Blending; Send Error Notifications To Specified Devices - Christie D4K2560 User Manual

Enable warping and blending

Use edge blending to combine several projected images into one single, seamless image. Use
warping to project images on any surface shape.
1. Create the warp and blend files using the Twist application
For details, see the Twist 2.0 User Manual (P/N: 020-101380-xx).
2. Upload the warp and blend files to the projector.
For details, see the Twist 2.0 User Manual (P/N: 020-101380-xx).
3. On the touch panel controller, tap Main > Configuration > Geometry.
4. To select a warp setting, tap Geometry Correction and tap the required warp.
5. To select a blend setting, tap Edge Blending and tap the required blend.
6. To select a black level blend setting, tap Black Level Blending and tap the required black level
blend.
7. To turn off warping, blending, or black level blending, tap Off.

Send error notifications to specified devices

If an error occurs on the projector, notifications can be sent to three different devices.
1. On the touch panel controller, tap Menu > Communications > SNMP.
2. Tap Trap IP Address 1.
3. For the device you want to send error notifications to, enter the IP address.
4. Tap OK.
5. To add a second or third device, repeat steps 2 to 4.
6. Select the options you want to monitor.
Options include lamp fault, lamp life, power, fan stall, and thermal sensors.
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
Operation
49