Projector Components - Christie D4K2560 User Manual

Projector components

A
ID Item
A Touch panel controller (TPC)
B LED status indicators
C Manual douser override
D Lamp door and lamps
E Exhaust duct and vane switch
F Liquid cooling air filter Ccver
and air filter
G Shroud (two-piece)
H Projection lens
I Air filter cover and air filter
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
D
B
C
B
J
LENS SIDE
Description
A touch-sensitive screen used to control and monitor operation. For
information about TPC controls and settings, see
LED color and blinking rates (located in both back corners of the projector)
provide information about the status of the projector. For information about
projector states and status, see
page 45.
Closing the douser rotates a shutter blade in front of the lamp and reduces
the lamp power to 2.0 kW to conserve lamp life. The override is for
emergency use only.
The lamp door provides access to the lamp compartment and must remain
closed and locked for normal operation. Lamp replacement should only be
performed by qualified technicians. For a complete list of available lamp
types, see
Extracts heated air from the lamp compartment. The vane switch mounted
inside the rigid port monitors airflow. See
Filters air before it circulates to cool the heat exchanger. For replacement
instructions, see
Covers the motorized lens mount assembly.
A variety of lenses can be used with the D4K2560Mirage 4K25. For a list of
available lenses, see on page 82
Filters the intake air before it circulates through the front compartment to
cool the main electronics. For replacement instructions, see
shutdown on page 57.
LAMP SIDE
E
I
LED expected behavior on power up on
Accessories on page 80.
Maintenance shutdown
Installation and Setup
F
G
H
Menus on page 50.
Site requirements on page 20.
on page 57.
Maintenance
22