Portrait mode
1. Orient the projector in the frame with the lamp door facing downward (as shown).
The maximum tilt angle is ±15 degrees.
2. Set up the customer-supplied mounting frame.
The mounting frame must be designed to accommodate the weight and mounting provisions of
the projector.
3. Remove the projector feet.
4. Attach the projector to the mounting frame using the four M12 holes (normally used for
projector feet) on the bottom side of the projector.
Mounting bolts must be grade 8.8 or higher and torqued to 60 ft-lbs.
5. Perform a lamp alignment.
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
Installation and Setup
30