Inaccurate display colors
•
Adjust the color, tint, color space, and color temperature settings of the input source.
•
On the touch panel controller, tap Menu > Configuration > Color Correction and verify the
settings are correct.
Display is not rectangular
•
Verify the projector is level and the lens surface and screen are parallel to one another.
•
Adjust the vertical offset of the lens mount.
Display has suddenly frozen
•
If the source is frozen, restart the source device.
•
If the source is not frozen, restart the projector.
Display is jittery or unstable
•
Verify that the input device is connected properly. If the input device is not connected properly,
the projector repeatedly attempts to display an image.
•
The horizontal or vertical scan frequency of the input signal may be out of range for the
projector.
For more details, see
Incoming signal(s) problems
The Status tab > Signal group contains information about all the signals that the projector receives.
A properly configured system shows the frequency and a status of Master or Locked for each input
in the selected channel.
•
If one or more of the signals are listed as No signal, verify that the source is properly
configured and the cables are secure between the source and the projector.
•
If one or more of the signals are listed as Inactive, either an incorrect channel has been
selected or the cables are not plugged into the correct inputs.
•
If one or more of the signals is listed as Unlocked or Out of phase, the source is not properly
frame locked to the master signal. This usually occurs when two independent sources are not
locked together. Verify the setup of the sources. If the sources are locked together, contact
Christie Technical Support for help.
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
Specification
on page 72.
Troubleshooting
69