•
Incorrect reporting of the lens motor position.
•
Inability to use the full range of the lens motors.
•
Lens motors traveling outside of the pre-defined keep-out area.
•
Damage to the projector.
Calibrate the lens motors when any of the following conditions are met:
•
After a lens change.
•
After the projector is moved and/or jostled.
•
After the lens motor IMCB has been replaced.
To calibrate the lens motors, on the touch panel controller, tap Lens > Calibrate Lens Motors.
Reset lens to home position
To reset the lens to the default home position, on the touch panel controller, tap Lens > Reset to
Home Position.
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
Maintenance
66