Led Expected Behavior On Power Up; Turn The Projector Off; Work With Lamps; Adjust Lamp Power - Christie D4K2560 User Manual

LED expected behavior on power up

The following table shows the expected behavior of the projector LED and the MCPU board power
LED on power up:
Action/Event
Applying AC power to the projector head
Within the first second
At approximately 30 seconds
At approximately 50 seconds
At approximately one minute and 15 seconds, the TPC indicates that it is connected and shows the
home page.

Turn the projector off

1. On the touch panel controller, tap the Home tab.
2. Tap Power.
When powering off in preparation for inspection or maintenance, always disconnect from AC
i
and set the projector breaker to the off positions.

Work with lamps

This section provides information and procedures for optimizing lamp performance to ensure the
brightest, most uniform image possible for the life of the lamp.

Adjust lamp power

1. On the touch panel controller, tap Menu > Lamp > Lamp Power.
2. Use the slider or enter a value to adjust the lamp power.
3. Tap OK.
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
Projector LEDs
Solid red
Solid green
Solid yellow
Solid red
Solid green
Solid yellow
Off red
Blinking yellow
Blinking green
Off/blinking red
Solid yellow
Off green
Operation
MCPU Board Power LED
Yellow
Blinking green
Blinking green
Solid green
45