How the projector works
The D4K2560 accepts a variety of input signals for projection on front or rear projection screens,
typical in commercial or other large screen applications. High-brightness light is generated by a
short arc Xenon lamp, then modulated by three Digital Micromirror Device (DMD) panels responding
to incoming data streams of digitized red, green and blue color information. As these digital
streams flow from the source, light from the responding "on" pixels of each panel is reflected,
converged and then projected to the screen through one or more projection lenses, where all pixel
reflections are superimposed in sharp full-color images.
List of components
Verify the following components were received with the projector:
•
Touch panel controller (TPC)
•
Lens plug (required for shipping when lens is not installed to prevent contamination of critical
optical components)
•
Light engine removal tool
•
Convergence tool
•
Nylon safety strap with clip (required to secure projector to tabletop or optional rack mount)
•
Warranty card
•
Shroud
•
Access keys
•
Web registration form
D4K2560 User Manual
020-101076-04 Rev. 1 (01-2015)
Introduction
19