IBM pSeries 690 Service Manual page 508

Error Code Description
4064 0011 Processor subsystem tests detected fault in
Memory book (slot 1)
4064 0012 Processor subsystem tests detected fault in
Memory book (slot 2)
4064 0013 Processor subsystem tests detected fault in
Memory book (slot 3)
4064 0014 Processor subsystem tests detected fault in
Memory book (slot 4)
4064 0015 Processor subsystem tests detected fault in
Memory book (slot 5)
4064 0016 Processor subsystem tests detected fault in
Memory book (slot 6)
4064 0017 Processor subsystem tests detected fault in
Memory book (slot 7)
4064 00B0 Processor subsystem tests detected possible
problem with bus controller or CSP code
4064 00B1 Processor subsystem tests detected possible
problem with bus controller
4064 00B3 Processor subsystem tests detected MCM
0/VPD problem
4064 00B4 Processor subsystem tests detected MCM
2/VPD problem
4064 00B5 Processor subsystem tests detected MCM
1/VPD problem
4064 00B6 Processor subsystem tests detected MCM
3/VPD problem
4064 00B7 Processor subsystem tests detected Insufficient
hardware resources to continue IPL after
processor subsystem testing and initialization
completed
488 Eserver pSeries 690 Service Guide
Action/
Possible Failing FRU
Memory book (slot 1)
Location: U1.18-P1-M3
Memory book (slot 2)
Location: U1.18-P1-M7
Memory book (slot 3)
Location: U1.18-P1-M6
Memory book (slot 4)
Location: U1.18-P1-M4
Memory book (slot 5)
Location: U1.18-P1-M8
Memory book (slot 6)
Location: U1.18-P1-M5
Memory book (slot 7)
Location: U1.18-P1-M1
1. Check for system firmware updates.
2. Primary I/O book,
Location: U1.18-P1-H2
3. Call service support.
1. Check for system firmware updates.
2. Primary I/O book,
Location: U1.18-P1-H2
3. Call service support.
1. Check for system firmware updates.
2. MCM module 0 and VPD card
Location: U1.18-P1-C1 and
U1.18-P1-H2.3
1. Check for system firmware updates.
2. MCM module 2 and VPD card
Location: U1.18-P1-C4 and
U1.18-P1-H2.4
1. Check for system firmware updates.
2. MCM module 1 and VPD card
Location: U1.18-P1-C3 and
U1.18-P1-H2.5
1. Check for system firmware updates.
2. MCM module 3 and VPD card
Location: U1.18-P1-C2 and
U1.18-P1-H2.6
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.