IBM pSeries 690 Service Manual page 833

Attention: If the client system and the server are on the same subnet, set the gateway IP address to
[0.0.0.0].
Selecting Adapter Configuration allows the setting of the network speed, enabling or disabling spanning
tree, and setting the protocol as shown in the following example menu:
Adapter Configuration
10/100 Mbps Ethernet PCI Adapter II: U1.9-P1-I4/E1
1. Speed, Duplex
2. Spanning Tree Enabled
3. Protocol
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Selecting the Speed, Duplex option allows you to set the interface speed at which the card will run and
half versus full duplex. The current setting is indicated by "<===".
Adapter Configuration
10/100 Mbps Ethernet PCI Adapter II: U1.9-P1-I4/E1
1. auto, auto
2. 10,half
3. 10,full
4. 100,half
5. 100,full
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
X = eXit System Management Services
X = eXit System Management Services
Chapter 8. Using System Management Services
813