I/O Subsystem Rio Riser Card - IBM pSeries 690 Service Manual

I/O Subsystem RIO Riser Card

Removal
Note: The RIO Riser Card is part of the I/O Subsystem Backplane FRU. It cannot be ordered separately.
1. Turn off power as described in "Powering Off and Powering On the System" on page 825.
2. Disconnect all cables from the RIO riser card.
3. Remove the I/O subsystem backplane, as described in "I/O Subsystem I/O Backplane Assembly" on
page 973.
4. Remove the two screws that attach the RIO riser card to the I/O subsystem backplane.
5. Carefully pull the card out of the slot as shown in the following illustration.
1 RIO Riser Card
Replacement
Replace in reverse order.
970 Eserver pSeries 690 Service Guide