IBM pSeries 690 Service Manual page 363

Step 1549-25
Replace the following books and modules, if present, one at a time:
v First location code item recorded, if any, in "Step 1549-1" on page 338.
v Second location code item recorded, if any, in "Step 1549-1" on page 338.
v Third location code item recorded, if any, in "Step 1549-1" on page 338.
v Memory book 6 at U1.18-P1-M5 if not recorded in "Step 1549-1" on page 338.
v Memory book 7 at U1.18-P1-M1 if not recorded in "Step 1549-1" on page 338.
v Primary I/O Book at U1.18-P1-H2 if not recorded in "Step 1549-1" on page 338.
Step 1549-26
Turn on the power.
Step 1549-27
Did the system stop with the same error code as recorded in "Step 1549-1" on page 338?
No The book or module just replaced was defective. This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
Yes Go to "Step 1549-28".
Step 1549-28
Have all the books or modules listed in "Step 1549-25" been replaced?
No Go to "Step 1549-2" on page 338.
Yes Go to "Step 1549-37" on page 344.
Step 1549-29
Replace the following books and modules, if present, one at a time:
v First location code item recorded, if any, in "Step 1549-1" on page 338.
v Second location code item recorded, if any, in "Step 1549-1" on page 338.
v Third location code item recorded, if any, in "Step 1549-1" on page 338.
v Secondary I/O Book at U1.18-P1-H3 if not recorded in "Step 1549-1" on page 338.
v Third I/O Book at U1.18-P1-H4 if not recorded in "Step 1549-1" on page 338.
v Fourth I/O Book at U1.18-P1-H1 if not recorded in "Step 1549-1" on page 338.
v Primary I/O Book at U1.18-P1-H2 if not recorded in "Step 1549-1" on page 338.
Step 1549-30
Turn on the power.
Step 1549-31
Did the system stop with the same error code as recorded in "Step 1549-1" on page 338?
No The book or module just replaced was defective. This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
Yes Go to "Step 1549-32" on page 344.
Chapter 3. Maintenance Analysis Procedures
343