IBM pSeries 690 Service Manual page 403

Table 2. Firmware Checkpoints (continued)
Checkpoint
E596
E59E
E59F
E5E0
E5E1
E5E2
E5E3
E5E4
E5E5
E5E6
E5E7
E5E8
E5E9
E5EE
Description
Read the EADS revision ID and class code 1. Replace the RIO cable specified by the
End of walking bus of current EADS
End of EADS initialization
Initialize system processor array
Reserved
Initialization of the hypervisor, phase 1
Not in quick-restart: load and set up open
firmware code in memory
Activate slave processors
Initialize the hypervisor, phase 2
Set L2 and processor status
Save I/O hub information for RTAS and
open firmware
Set up registers
Reset the quick restart path
Hang state in main control code
Action/
Possible Failing FRU
location code.
2. Replace the I/O subsystem planar to
which the RIO cable in Step 1 is
attached.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.
Chapter 4. Checkpoints
383