IBM pSeries 690 Service Manual page 393
Hide thumbs
Also See for pSeries 690:
- Service manual (1134 pages) ,
- User manual (277 pages) ,
- Installation manual (230 pages)
Table of Contents
Advertisement
Table 2. Firmware Checkpoints (continued)
Checkpoint
E529
E52A
E52B
Description
Enable the control port and driver of the
current RIO hub
Search for the next available I/O drawer
from a current RIO port
The RIO cable connected to the RIO port
has been detected
Action/
Possible Failing FRU
1. Check the RIO cable specified by the
location code. If the location code
specifies an I/O subsystem or its RIO
interface, check the RIO cables going
into and out of the I/O subsystem.
2. Replace the RIO cables specified by
the location code. If the location code
specifies an I/O subsystem or its RIO
interface, replace the RIO cables going
into and out of the I/O subsystem.
3. Replace the I/O book specifed by the
location code, or the I./O book that the
RIO cables in step 1 are attached to.
4. Replace the I/O subsystem backplane
specified by the location code, or the
I/O subsystem backplane that the RIO
cables in step 1 are attached to.
1. Check the RIO cable specified by the
location code. If the location code
specifies an I/O subsystem or its RIO
interface, check the RIO cables going
into and out of the I/O subsystem.
2. Replace the RIO cables specified by
the location code. If the location code
specifies an I/O subsystem or its RIO
interface, replace the RIO cables going
into and out of the I/O subsystem.
3. Replace the I/O book specifed by the
location code, or the I./O book that the
RIO cables in step 1 are attached to.
4. Replace the I/O subsystem backplane
specified by the location code, or the
I/O subsystem backplane that the RIO
cables in step 1 are attached to.
1. Check the RIO cable specified by the
location code. If the location code
specifies an I/O subsystem or its RIO
interface, check the RIO cables going
into and out of the I/O subsystem.
2. Replace the RIO cables specified by
the location code. If the location code
specifies an I/O subsystem or its RIO
interface, replace the RIO cables going
into and out of the I/O subsystem.
3. Replace the I/O book specifed by the
location code, or the I./O book that the
RIO cables in step 1 are attached to.
4. Replace the I/O subsystem backplane
specified by the location code, or the
I/O subsystem backplane that the RIO
cables in step 1 are attached to.
Chapter 4. Checkpoints
373
Advertisement
Chapters
Table of Contents
