Operator Panel - IBM pSeries 690 Service Manual

Operator Panel

Removal
1. Turn off power as described in "Powering Off and Powering On the System" on page 825.
2. Remove the upper-left and lower-right screws that hold the media subsystem in the rack, and pull the
subsystem out no more that two inches.
3. Pry the spring clip on the left side just enough to release the panel while grasping the operator panel
by the top and bottom front (do not pull on the bezel). Pull the operator panel out of the chassis.
4. Note the locations and disconnect the cables from the operator panel, and then remove the operator
panel as shown in the following illustration.
Replacement
1. Remove the VPD module from the old operator panel and insert it in the new operator panel. Make
sure you insert the module in the same position as it was in the old panel.
2. Reconnect the cables to the operator panel.
3. Push the operator panel into the chassis until the spring clip engages.
4. Push the chassis into the rack, and replace the two mounting screws.
5. Turn on the power as described in "Powering the System On" on page 826.
984 Eserver pSeries 690 Service Guide