Short Adapter Or Blank Filler Installation - IBM pSeries 690 Service Manual

Hide thumbs Also See for pSeries 690:

Table of Contents

3. Remove the adapter or blank filler and ensure that the handle is in the up position. If you need to

move the handle, ensure that the locking bar is pulled into the unlocked position, and then rotate the

adapter handle until the handle is in the up position (the cassette linkage assembly will extend down

beyond the cassette top).

If you are installing a short adapter or blank filler, go to "Short Adapter or Blank Filler Installation". If

you are installing a long adapter, go to "Long Adapter Installation" on page 950.

Short Adapter or Blank Filler Installation

To install a short adapter or blank filler, do the following:

1 Handle Release Lever

Chapter 9. Removal and Replacement Procedures

Table of Contents