IBM pSeries 690 Service Manual page 505

Error Code Description
2B2x 00EE An exception error has been reported on a
global processor
2BA0 0000 Service processor POST failure
2BA0 0012 Service processor reports self test failure
2BA0 0013 Service processor reports bad NVRAM CRC
2BA0 0017 Service processor reports bad or low battery.
2BA0 0021 Open firmware mailbox call to activate
attention LED failed
2BA0 0041 Service processor VPD is damaged.
2BA0 0071 VPD data is damaged for MCM 0
2BA0 0073 VPD data is damaged for MCM 2
2BA0 0080 Service processor hardware reset request
failure
2Cmm mhhh A processor's timebase enable signal is stuck
enabled
Action/
Possible Failing FRU
The type of interrupt that caused the
exception is specified by the x as follows:
0: Unknown interrupt
1: System reset interrupt (SRI)
2. Machine check interrupt (MCI)
3. Data storage interrupt (DSI)
4. Instruction storage interrupt (ISI)
5. External interrupt (EXI)
6. Alignment interrupt (ALI)
7. Program interrupt (SRI)
8. Floating unavailable interrupt (FUI)
1. Check for system firmware updates. Apply
if available.
2. Call service support.
Replace the primary I/O book,
Location: U1.18-P1-H2
Replace the primary I/O book,
Location: U1.18-P1-H2
Refer to the actions for 25A8 0xxx.
Refer to the actions for 25A8 0xxx.
1. Check for system firmware updates. Apply
if available.
2. Call service support.
Replace the primary I/O book,
Location: U1.18-P1-H2
Replace the MCM and VPD card
Replace the MCM and VPD card
1. Check for system firmware updates. Apply
if available.
2. Call service support.
1. Replace the primary I/O book, location:
U1.18-P1-H2.
2. hhh indicates the failing processor.
Replace the MCM that contains the failing
processor according to the following table:
v hhh = 0 - 7: U1.18-P1-C1
v hhh = 8-15: U1.18-P1-C3
v hhh = 16-23: U1.18-P1-C4
v hhh = 24-31: U1.18-P1-C2
Chapter 5. Error Code to FRU Index
485