F.6 Fcc Declaration Of Conformity - Image Access WideTEK 48C Operation Manual

F.6 FCC Declaration of Conformity
Responsible party:
Image Access GmbH
Hatzfelder Strasse 161 – 163
42281 Wuppertal, Germany
Product:
Model Designation:
Serial number:
This devices comply with FCC, Part 15, Class B and ICES-003.
The test setup F≤ 1000 MHz and test was done according to
ANSI C63.4: 2009 and CISPR 22: 2006+A1:2007
Compliance with CISPR 22 is being used to demonstrate conformity with FCC DoC
requirements. This conforms with FCC Part 15.107(e) and 15.109(g).
The test setup F> 1000 MHz and test was done according to
ANSI C63.4: 2009
American National Standard for Methods of Measurement of Radio-Noise Emissions from
Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz.
NOTE: This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced technician for help.
Page 86
WideTEK 36C / WideTEK 48C Scanner
WT 36C-XXX / WT48C-XXX
(
XXX represents the device version number and configuration details)
All
Manual