B Touchscreen Operation; Select Application - Image Access WideTEK 48C Operation Manual

B Touchscreen Operation
The scanner can be controlled in two ways.
•
Via the integrated touchscreen.
•
Via a standard browser and the ScanWizard user interface. A short introduction of the
functions of the integrated ScanWizard user interface starts in chapter C.
Please note: All screenshots are taken from a fully equipped device with all options
and functions activated. Depending on the selected mode, the menus
displayed on the screen can vary.
GENERAL NOTICE
This manual describes the functions of a complete equipped scanner. If your device is not
equipped with all features, deviations are possible.
B.1

Select Application

When the scanner starts from standby mode and finishes the startup procedure, the
touchscreen displays for approximately ten seconds the screen Select Application.
Touching this button will switch to a user programmable application.
This enables the user to operate the scanner with a customized
application.
As factory default the EasyScan application is integrated.
To leave the application, the scanner must be restarted.
Touching this button switches to the start screen of the integrated
kiosk application.
Chapter B.2 to chapter B.6 and the corresponding subchapters
describe the available functions.
Page 28
Picture 14: Start screen after start-up
Manual