B Touchscreen Operation - Image Access WideTek 36C Manual

B Touchscreen Operation
The WideTEK ® 36C
•
Via the integrated touchscreen. The functions of the touchscreen are described
starting with chapter B.2.
•
Via a standard browser and the ScanWizard user interface. A short introduction of the
functions of the integrated ScanWizard user interface starts in chapter C.
Please note: All screenshots are taken from a fully equipped device with all options
and functions activated. Depending on the selected mode, the menus
displayed on the screen can vary.
GENERAL NOTICE
This manual describes the functions of a complete equipped WideTEK
your device is not equipped with all features, deviations are possible.
B.1 Select Application Screen
When the WideTEK
procedure, the touchscreen displays for approximately ten seconds the screen
Select Application
Touching this button will switch to a user programmable application.
This enables the user to operate the scanner with a customized
application.
As factory default the EasyScan application is integrated.
To leave the application, the scanner must be restarted.
Touching this button switches to the start screen of the integrated
kiosk application.
Chapter B.2 to chapter B.6 and the corresponding subchapters
describe the available functions.
Page 24
scanner can be controlled in two ways.
36C
®
scanner starts from standby mode and finishes the startup
Picture 10: Start screen after start-up
® 36C
scanner. If
Manual