Gpi/Gpo Cables Installation - Doremi IMS1000 Installation And User Manual

4.5

GPI/GPO Cables Installation

GPO
GPI
● Plug one shielded CAT5 or CAT6 cable end into the connector labeled GPI on the
IMS1000 board (Figure 23). Install a ferrite core clamp near the connector closest to the
IMS1000. Refer to Section 25 for more information on ferrite core clamp installation.
● Plug the other end of the shielded CAT5 or CAT6 cable into whichever automation
controller is available or required.
● Take another shielded CAT5 or CAT6 cable and plug the end into the IMS1000
connector labeled GPO (Figure 23). Install a ferrite core clamp near the connector
closest to the IMS1000. Refer to Section 25 for more information on ferrite core clamp
installation.
● Plug the other end of the shielded CAT5 or CAT6 cable into whichever automation
controller is available or required.
IMS.OM.002949.DRM
Figure 22: RJ-45 to DB25 Converter
Figure 23: GPI/GPO Connectors
Page 42 of 310
Doremi Labs
Version 1.4