Solution - Doremi IMS1000 Installation And User Manual

Aug 6 12:39:27 ims1000 kernel: ata2: exception Emask 0x10 SAct 0x0 SErr 0x4050000 action
0xe frozen
Aug 6 12:39:27 ims1000 kernel: ata2: irq_stat 0x00400040, connection status changed
Aug 6 12:39:27 ims1000 kernel: ata2: SError: { PHYRdyChg CommWake DevExch }
Aug 6 12:39:27 ims1000 kernel: ata2: hard resetting link
Aug 6 12:39:33 ims1000 kernel: ata2: link is slow to respond, please be patient (ready=0)
Aug 6 12:39:37 ims1000 kernel: ata2: softreset failed (device not ready)
Aug 6 12:39:37 ims1000 kernel: ata2: hard resetting link
Aug 6 12:39:47 ims1000 kernel: ata2: softreset failed (device not ready)
...
Aug 6 12:40:22 ims1000 kernel: ata2: limiting SATA link speed to 1.5 Gbps
Aug 6 12:40:22 ims1000 kernel: ata2: hard resetting link
Aug 6 12:40:28 ims1000 kernel: ata2: softreset failed (device not ready)
Aug 6 12:40:28 ims1000 kernel: ata2: reset failed, giving up
Aug 6 12:40:28 ims1000 kernel: ata2: EH complete

17.3.3 Solution

Install ims_sw_hotfix_esata-1.0.0.pkg or software version 2.5.3 or higher.
17.4 Audio Delay Issue
17.4.1 Description
There is an important audio delay in the setup. There is an intermittent loss of
audio synchronization with the video. Typically content starts out with in sync audio but
gradually an audio delay is noticeable.
17.4.2 Identification
No error in the logs.
17.4.3 Solution
Install ims_sw_hotfix_audio_delay-2.4.4.pkg or software version 2.5.4 or higher.
17.5 Communication Issue with Dolby CP650
17.5.1 Description
The unit is not communicating properly with a Dolby CP650 audio processor using
is working fine on Eth0.
17.5.2 Identification
Dolby CP650 can be controlled, using macros, when connected with Eth0 interface but
cannot be controlled when connected with Eth1 ethernet interface.
17.5.3 Solution
Install ims_sw_hotfix_smsc75xx-1.0.2.pkg.
IMS.OM.002949.DRM Page 277 of 310
Doremi Labs
Eth1, but
Version 1.4