Removing A Device Or Projector - Doremi IMS1000 Installation And User Manual

● Specify a projector identifier (e.g., projector name, screen #) in the first field.
○ Note: For projector types, please select Primary. Also, this could apply if the user
were to use dual projector for 3D (left projector would be Primary and right
projector would be Secondary).
● Choose the correct Series-2 projector model to connect to the unit using the Projector
model field(s).
● Select the model Series-2 for the projector from the drop-down menu on the right.
● Enter the IP address. The Test button will allow you to test the IP connection prior to
saving (Figure 126).
● Choose to either enable or disable the subtitles.
● Check the Enabled check box at the top right corner of the GUI.
● Click the Save button to record the settings (Figure 126). A password confirmation page
will appear. Enter the password to save and record the settings. SuperUser privileges
are necessary to confirm the changes. If the user is already logged in with SuperUser
privileges, the password confirmation window will not appear. Clicking the Revert button
prior to saving will delete the unsaved information (Figure 126).
12.3.1.1

Removing a Device or Projector

● To remove a device or projector, click on it in the left part of the Device Manager GUI.
● Click the Delete Device button (Figure 126).
12.3.2 Automation Libraries Management

Support for theater automation control is also provided. The list of currently supported
devices is the following:
o eCNA
o JNior
o
A pre-built library of supported automation commands is available for each of
these two devices. These automation commands can then be added to Macro
Cues.
12.3.3 Adding an eCNA Device

To add the eCNA device, click the New Device button in the Device Manager window
(Figure 123).

The New Device drop-down window will appear. Select eCNA.

The Device Manager GUI will be updated to reflect the addition of the eCNA device.

Input the eCNA Server IP address in the appropriate field (Figure 127).

If not already done, check the Enabled check-box in the top-right corner of the GUI.

Click the Save button to record the settings. A window asking for the password will
appear. Enter the password to save the settings and proceed. Clicking the Revert button
prior to saving will delete the unsaved information (Figure 126).
IMS.OM.002949.DRM Page 116 of 310
Doremi Labs
Version 1.4