Table of Contents
Advertisement
3. Check the Ethernet cable between the projector and the laser system network switch is
securely attached.
4. Check the Ethernet cable between the laser bank manager and the laser system network switch
is securely attached.
5. Turn on the laser bank manager.
6. Turn on the circuit breaker on the projector baseplate under the front lens-side corner.
7. If the emergency-stop button on either the Laser Rack or the projector is activated, release it
by turning the button clockwise.
8. Turn the Beam Stop on the projector to OPEN.
9. Turn the Laser Rack key switch on.
The key must be in the switch at all times.
10. Turn on the laser system network switch at the rear of the Laser Rack.
11. Turn on the breakers (one per laser module) in the power distribution unit in the front of the
Laser Rack.
12. Press MANUAL RESET on the side of the Laser Rack or on the back of the projector.
Wait for a few seconds for the interlock to close and the laser emission status lights on the rear
of the projector to turn on.
13. To turn on the projector, on the Home tab on the touch panel controller (TPC), tap Power.
14. Verify the status lights on the back of the projector and the front of the laser modules are
white.
Test the interlocks
Once the projector is running, ensure the safety interlocks are functioning.
Before displaying an image from the projector, test the three interlock devices. Every time
the interlock is activated, the laser modules turn off. Failure to comply could result in death
or serious injury.
Test the key switch
1. Turn the key switch on the Laser Rack off.
2. Check the status lights on the back of the projector are off.
3. Turn on the key switch.
4. Press Manual Reset on the projector.
Test the Laser Rack emergency stop
1. Press the emergency stop button on the Laser Rack.
2. Check the status lights on the back of the projector are off.
D4KLH60/Mirage 4KLH User Manual
020-101375-02 Rev. 1 (06-2015)
Operate the Projector
23
Advertisement
Table of Contents
