Table of Contents
Advertisement
Serial Commands
Ambles to Source (External Data Routing)
Serial Cmd:
<K161,mode,destination
end of read cycle,output at ETX,output at timeout>
Default:
0 = Disabled
Options:
0 = Disabled
Echo to Source (External Data Routing)
Serial Cmd:
<K161,mode,destination port,ambles to
end of read cycle,output at ETX,output at timeout>
Default:
0 = Disabled
Options:
0 = Disabled
Output at End of Read Cycle (External Data Routing)
Serial Cmd:
<K161,mode,destination port,ambles to source,echo to
end of read
Default:
0 = Disabled
Options:
0 = Disabled
Output at ETX (External Data Routing)
Serial Cmd:
<K161,mode,destination port,ambles to source,echo to source,output at
end of read
Default:
CR (0x0D)
Options:
Any 7-bit ASCII character
Output at Timeout (External Data Routing)
Serial Cmd:
<K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at
Default:
200 (x10 ms = 2 seconds)
Options:
0 – 65535
Array Communication Modes
Mode (Array Communication Modes)
Serial Cmd:
<K162,mode,source,daisy chain i.d. status,daisy chain i.d.>
Default:
0 = Disabled
Options:
0 = Disabled
A-40
port,ambles to
1 = Enabled
1 = Enabled
cycle,output at ETX,output at timeout>
1 = Enabled
cycle,output at
ETX,output at timeout>
ETX,output at
1 = Daisy Chain
source,echo to source,output at
source,echo to
source,output at
source,output at
timeout>
QX Hawk Industrial Imager User Manual
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the QX Hawk and is the answer not in the manual?
Questions and answers