Table of Contents
Advertisement
Read Rate Serial Utility Commands
Perform Decodes / Second Test
Sending
<C>
instructs the imager to transmit the decodes per second and symbol data
(if any). The decode rate can vary dramatically due to the angle and location of the symbol
in relation to the field of view. This test is very useful in aligning and positioning the imager
during setup.
Perform Decode Percent Test
Sending
<Cp>
instructs the imager to transmit the percentage of decodes and any
decoded symbol data.
Exit Decodes / Second and Decode Percent Tests
Sending
<J>
ends both the Percent test and the Decodes/Second test.
QX Hawk Industrial Imager User Manual
Utilities
7-5
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the QX Hawk and is the answer not in the manual?
Questions and answers