Show Station; Iapp Command; Iapp - HP procurve 420 Management And Configuration Manual

Command Line Reference

IAPP Command

6-80

show station

This command shows the wireless clients associated with the access point.
The "Station Address" displayed is the client's MAC address.
Command Mode
Exec
Example
HP420#show station
802.11g Station Table
Station Address
Authenticated
Associated
Forwarding Allowed
HP420#

IAPP Command

The command described in this section enables the protocol signaling
required to ensure the successful handover of wireless clients roaming
between different IEEE 802.11f-compliant access points. The IEEE 802.11f
protocol can ensure successful roaming between access points in a multi-
vendor environment.

iapp

This command enables the protocol signaling required to hand over wireless
clients roaming between different 802.11f-compliant access points. Use the no
form to disable 802.11f signaling.
Syntax
iapp
no iapp
Default
Enabled
Command Mode
Global Configuration
: 00-04-E2-41-C2-9D
: TRUE
: TRUE
: TRUE