Filtering Commands; Filter Local-Bridge - HP procurve 420 Management And Configuration Manual

Filtering Commands

The commands described in this section are used to filter communications
between wireless clients, control access to the management interface from
wireless clients, and filter traffic using specific Ethernet protocol types.
Command Function

filter local-bridge

Disables communication between wireless clients
filter ap-manage Prevents wireless clients from accessing the
management interface
filter ethernet-type Checks the Ethernet type for all incoming and outgoing
enable Ethernet packets against the protocol filtering table
filter ethernet-type Sets a filter for a specific Ethernet type
protocol
show filters Shows the filter configuration
filter local-bridge
This command disables communication between wireless clients. Use the no
form to disable this filtering.
Syntax
filter local-bridge
no filter local-bridge
Default
Disabled
Command Mode
Global Configuration
Command Usage
This command can disable wireless-to-wireless communications between
clients via the access point. However, it does not affect communications
between wireless clients and the wired network.
Command Line Reference

Filtering Commands

Mode Page
GC 6-47
GC 6-48
GC 6-48
GC 6-49
Exec 6-50
6-47