HP procurve 420 Management And Configuration Manual page 32

Using the Command Line Interface (CLI)
Using the CLI
HP420(config)#?
Configure commands:
802.1x
address
end
exit
filter
help
iapp
interface
ip
logging
mac-authentication
native-vlanid
no
password
prompt
radius-server
snmp-server
sntp-server
system
username
---More---
When - - MORE - - appears, use the Space
bar or [Return] to list additional
Figure 3-4. Example of the Configuration-Level Command Listing
3-8
Typing ? at the Configuration level produces this listing:
Set 802.1x
Set address
Return to previous mode
Exit to the EXEC mode
Bridge protocol filtering
Description of the help system
Enable IAPP
Into the interface configure mode
Set IP
Modify message logging facilities
Set RADIUS MAC Authentication
Set Native VLAN ID <1-4095>
Negate
Assign the privileged password(max length:16)
Set system's prompt
Set radius server
Modify SNMP parameters
Set SNTP
Set system name
Set username
When - - MORE - - appears, there are more commands in the listing. To list the
next set of commands, press the Space bar. To list the remaining commands
one-by-one, repeatedly press
Typing? at the Global Configuration level or the Context Configuration level
produces similar results. In a particular context level, the first block of
commands in the listing are the commands that are most relevant to the
current context.
Use To Complete a Command Word. You can use
[Tab]
complete the current word in a command. To do so, type one or more
consecutive characters for a command and then press
allowed). The CLI completes the current word (if you have typed enough of
.
[Enter]
to quickly
[Tab]
(with no spaces
[Tab]