HP procurve 420 Management And Configuration Manual page 27

C a u t i o n
When you use the CLI to log on to the access point, you will be prompted to
enter a password. For example:
Ready
Username: admin
Password:
Figure 3-1. Example of CLI Log-On Screen with Password
When you log onto the CLI, you will see a command prompt:
HP420#_
HP strongly recommends that you configure a Manager password. If a Man-
ager password is not configured, the access point is not password-protected,
and anyone having in-band or out-of-band access to the access point may be
able to compromise access point and network security.
Pressing the Reset button on the back of the access point for more than five
seconds removes password protection. For this reason, it is recommended
that you protect the access point from physical access by unauthorized
persons.
Using the Command Line Interface (CLI)
Password Prompt
Using the CLI
3-3