HP procurve 420 Management And Configuration Manual page 119

Command Syntax
multicast-cipher <AES | TKIP | WEP>
wpa-psk-type <type>
wpa-preshared-key <type> <value>
show interface wireless g
show station
Using the CLI to Configure WPA. To configure the access point to sup-
port only WPA-enabled clients, be sure to set the access point to "open system"
and set 802.1x authentication to "required."
The following example shows how to configure access point security for WPA.
This example assumes that a RADIUS server is configured and available on
the wired network, it also assumes that the RADIUS server parameters are
configured on the access point.
HP420(config)#802.1x required
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless g)#wpa-clients required
HP420(if-wireless g)#wpa-mode dynamic
HP420(if-wireless g)#multicast-cipher tkip
HP420(if-wireless g)#authentication open
HP420(if-wireless g)#encryption 128
HP420(if-wireless g)#
Access Point Configuration
Configuring Wireless Security
CLI Reference Page
page 6-73
page 6-76
page 6-76
page 6-78
page 6-80
5-61