Address Filter Default; Address Filter Entry - HP procurve 420 Management And Configuration Manual

address filter default

This command sets filtering to allow or deny listed MAC addresses.
Syntax
address filter default <allowed | denied>
• allowed - Only MAC addresses entered as "denied" in the address
filtering table are denied.
denied - Only MAC addresses entered as "allowed" in the address
•
filtering table are allowed.
Default
allowed
Command Mode
Global Configuration
Example
HP420(config)#address filter default denied
HP420(config)#
Related Commands
address filter entry (page 6-43)
show authentication (page 6-46)

address filter entry

This command enters a MAC address in the filter table.
Syntax
address filter entry <mac-address> <allowed | denied>
mac-address - Physical address of client. Enter six pairs of hexadec-
•
imal digits separated by hyphens, e.g., 00-90-D1-12-AB-89.
allowed - Entry is allowed access.
•
• denied - Entry is denied access.
Default
None
Command Line Reference
802.1x Port Authentication
6-43