Cli: Configuring Ieee 802.1X - HP procurve 420 Management And Configuration Manual

CLI: Configuring IEEE 802.1x

CLI Commands Used in This Section
Command Syntax
interface <ethernet | wireless g>
authentication <open | shared>
[no] 802.1x <supported | required>
802.1x broadcast-key-refresh-rate <rate>
802.1x session-key-refresh-rate <rate>
802.1x session-timeout <seconds>
show authentication
The following example shows how to configure 802.1x authentication to be
required by all clients, as well as setting broadcast and session key refresh
rates and a re-authentication timeout.
HP420(config)#interface wireless g
HP420(if-wireless g)#authentication open
HP420(if-wireless g)#end
HP420(config)#802.1x required
HP420(config)#802.1x broadcast-key-refresh-rate 5
HP420(config)#802.1x session-key-refresh-rate 5
HP420(config)#802.1x session-timeout 600
HP420(config)#
Access Point Configuration
Configuring Wireless Security
CLI Reference Page
page 6-53
page 6-67
page 6-40
page 6-41
page 6-41
page 6-42
page 6-46
5-69