Show Station; Iapp Command; Iapp - HP ProCurve 420 Management And Configuration Manual

show station

This command shows the wireless clients associated with the access point.
The "Station Address" displayed is the client's MAC address.
Command Mode
Exec
Example
HP420#show station
802.11g Station Table
Station Address
Authenticated
Associated
Forwarding Allowed
HP420#

IAPP Command

The command described in this section enables the protocol signaling
required to ensure the successful handover of wireless clients roaming
between different IEEE 802.11f-compliant access points. The IEEE 802.11f
protocol can ensure successful roaming between access points in a multi-
vendor environment.

iapp

This command enables the protocol signaling required to hand over wireless
clients roaming between different 802.11f-compliant access points. Use the no
form to disable 802.11f signaling.
Syntax
iapp
no iapp
Default
Enabled
Command Mode
Global Configuration
: 00-04-E2-41-C2-9D
: TRUE
: TRUE
: TRUE
Command Line Reference

IAPP Command

6-77